NDISTest 6.5 - WlanOffloads - OSStack

This automated test verifies the WLANOffloads.

Test details

Associated requirements	Device.Network.WLAN.Base.MeetScanAndConnReq Device.Network.WLAN.CSBBase.MeetScanAndConnReq Device.Network.WLAN.CSBWoWLAN.MustSupportWakeOnWLAN Device.Network.WLAN.WoWLAN.ImplementWakeOnWLAN See the device hardware requirements.
Platforms	Windows RT (ARM-based) Windows 8 (x64) Windows 8 (x86) Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86
Expected run time	~40 minutes
Categories	Certification Functional
Type	Automated

Before you run the test, complete the test setup as described in the test requirements: Wireless LAN (802.11) Testing Prerequisites.

The KeepAlive suite is available in this test and consists of the following test:

Name	Description
Pre-configuration	Rebind the operating system stack on the DUT and the SUT. Configure one of the access point to use WPA2/AES.
Protocol offload test	Enable Protocol offload for protocols specified by m_TestProtocols and test for a successful offload.
Interception test	Test that the offload protocols are bypassed by the test device firmware after the device resumes following a successful protocol offload.
Invalid packet test	Verify that no responses on invalid packets are received from the test adapter with offload enabled.
Traffic test	Verify that no response for packets sent to other hosts on the same subnet are sent by test adapter with offload enabled.
Enable disable test	Verify no response for packets sent for following configurations: Disable protocol offload but program protocol offloads with OID_PM_ADD_PROTOCOL_OFFLOAD. Test for a failed offload. Disable protocol offload and do not program protocols for offload.
Protocol offload capacity test	Add as many IPv4 ARP protocol offloads as the driver supports, and test the first address, last address, and any random IPv4 offloaded address in between by sending an ARP request packet when in sleep state. Perform the same test as above for IPv6 NS offload. Add a single IPv6 target address in each offload request. Perform the same test as above for IPv6 NS offload, but add two target addresses in each offload request. Test the first two addresses and the last address added to the IPv6 target address.

Parameter	Description
AP1Password	The root password for the first physical access point.
AP1IPAddress	The IP address of the WAN port of the first physical access point.
AP2Password	The root password for the second physical access point.
AP2IPAddress	The root password for the second physical access point.